The OMI 196LS PFC synergic machine is equipped with the PFC system "Power Factor Correction" - power factor compensation, which allows operation on single-phase networks with AC voltage 1x230V (-30% / + 15%).
Advantages of the PFC function:
1. The machine can be connected to an AC 160V - 265V power supply.
2. The welding machine is suitable for operation on power plants or for very long extension cables due to the very low susceptibility to undervoltage and mains overvoltage.
3. Lower level of electromagnetic interference.
4. Higher efficiency thanks to which the circuit breaker is not stressed much (the circuit breaker switches off later than for devices without PFC).
The OMI 195LS PFC semi-automatic inverter welding semi-automatic allows parameters to be set manually or by synergy. It is also possible to electronically set the point length, long point welding values or switch the machine to two-stroke or four-stroke mode. Digital V-A meter. Two-roll welding wire feeder. It is possible to connect 3,4,5 m burners with a Euro connector.
The machine is equipped with a digital control board for setting all functions using buttons and displays the welding process on two separate displays. Functions can be set: pre-blow, trip / ramp current, electronic choke setting, burn-in / ramp-down current, afterblow, points, spot welding, 2T, 2T points, 2T pulses, 4T, 4T points, 4T pulses.
The design of the OMI welding machine guarantees high source reliability, excellent welding properties in a wide range of applications. All types of low-alloy and high-alloy steels as well as aluminum and its alloys can be welded using a suitable protective atmosphere. Possibility of welding aluminum:
Aluminum can be welded by the MAG method only with AlMg5 wire with a diameter of 1.0 mm or 1.2 mm with a torch max. 3 m long equipped with a Teflon bowden cable, branded current tips designed for aluminum welding. The wire feeder must be fitted with a pulley with a U-profile.
Welded aluminum parts must have a wall of min. 2 mm.Aluminum welding accessories tested by OMICRON- welding machines s.r.o. is delivered in a set or individually via OMICRON welding machine dealers.
Loader: Measured at 40 ° C
MIG welding in a protective atmosphere
25% - 195A - 22.75V,
60% - 140A - 21V,
100% - 120A - 20V
